Changing Hydraulic Oil Filters

causym CAUTION: Do not attempt to remove or service the hydraulic oil filters while the engine is running.

The hydraulic return oil filter (A) and charge filter (B) are located in the upper area of the hydraulic component compartment located on the left-hand side of the windrower behind the operator's station.

1. Lower platform to the ground.

NOTE: Place a bucket under drip pan (C) drain hose.

2. Remove filter(s).

3. Apply a light coat of hydraulic oil to seal before installing filters.

4. Tighten filter(s) until filter seal contacts mounting surface. Tighten an additional 1/2 turn.

causym CAUTION: Do not check filter seals for leaks when engine is running.

5. Start engine and allow to run for several minutes.

6. Stop engine, wait a few minutes and visually check filter seals for leaks.

E43036
E43037


A-Return Oil Filter
B-Charge Filter
C-Drip Pan

AG,OUO6038,1190 -19-11OCT99-1/1