Digital Display - Program Change (*if equipped)
Data indicated by digital display are function of the different possibility of configuration of tractors like:
- Engine type (3 or 4 cylinders)
- Gear box type (12+12 or 24+24 speeds)
- PTO rpm (540/540E or 540 / 1000 rpm)
- Tire size
If in field, for any reason, one of this factor is changed (i.e. different tires are installed), a new program number has to be set .
This number has to be chosen between a range resuming all different configurations.
Refer to the chart below.
Example:
Actual tractor configuration:
-
3cyl.-12+12 speeds › 540/540E PTO and rear wheels 420/70-24
-
Corresponding program number is 19
Change required:
-
New wheels 16.9R30
-
corresponding new program number is 3
How to set new program number
1.
With the ignition key in "OFF" position press the program button (G), then turn the key to 1st position clockwise.
2.
Release the button: the display (F) will show "SET".
3.
Press again the button until the new program number (3 of the example) is displayed.
4.
Release the button. The display will show "OFF".
5.
Turn the ignition key counterclockwise.
Setting operation is completed.
|