|
Insufficient transport clearance
|
Center link too long.
|
Adjust center link.
|
|
|
Lift links to long.
|
Adjust lift links.
|
|
|
Implement not level.
|
Level implement.
|
|
|
Implement not properly adjusted.
|
See implement operator's manual.
|
|
|
Front of center link in upper holes.
|
Move center link to lower holes.
|
|
|
Sway chains adjusted to short.
|
Lengthen sway chains.
|
|
Hitch drops slowly
|
Rockshaft rate-of-drop control not properly set.
|
Adjust rate-of-drop knob.
|
|
Hitch fails to lift or lifts slowly
|
Excessive load on hitch.
|
Reduce load.
|
|
|
Hitch fails to lift or lifts slowly
|
Adjust flow control valve and /or change priority
|
|
|
Low oil level.
|
Fill system with proper oil.
|
|
|
Hydraulic oil too cold.
|
Allow oil to warm.
|
|
|
Transmission-hydraulic oil filter clogged.
|
Replace filter.
|
|
|
Transmission-hydraulic filter screen clogged.
|
Clean or replace screen.
|
|
Implement will not operate at desired depth
|
Lift links too short.
|
Adjust lift links.
|
|
|
Lack of penetration.
|
See implement operator's manual
|
|
|
Improper setting of limit stop.
|
Reset position limit.
|
|
|
Improper setting of draft lever.
|
See in Section 50 "Rockshaft and Three-Point Hitch".
|
|
Insufficient or no hitch response to draft load
|
Front attachment of center link in upper holes.
|
Move center link attachment to lower bracket holes.
|
|
|
Draft control lever in "Off" position.
|
Move lever rearward.
|