Adjust Toe-In

Without Front Wheel Drive

1. Loosen lock nuts (A) and back out the bolts (B) on tie rod tubes several turns.

2. Adjust tie rods on both sides of the tractor equally by rotating the inner tube (C) to lengthen or shorten tie rod. Adjust toe-in to 3 to 6 mm (1/8 to 15/64 in.)

Tie Rod Rotation Approximate Change in Toe-in
1/2 turn 8 mm (5/16 in.)
1 turn 16 mm (5/8 in.)

 

3. Tighten bolts (B) to 85 N·m (62 lb-ft). Do not over tighten as damage to the tube may occur.

4. Tighten the lock nuts (A) to 90 N·m (66 lb-ft).

M46965

OULXA64,0000321 -19-28JUN01-1/2

With Front Wheel Drive

1. Loosen jam nuts (A) on both ends of tie rod.

2. Adjust both sides equally by rotating the inner rod (B) to lengthen or shorten tie rod, as needed to obtain toe-in of less than 3 mm (1/8 in.).

Tie Rod Rotation Approximate Change
1/8 turn 4 mm (3/16 in.)
1/4 turn 8 mm (3/8 in.)
1/2 turn 16 mm (5/8 in.)

 

3. Tighten jam nuts after adjustment.

M47182A

OULXA64,0000321 -19-28JUN01-2/2