Insufficient transport clearance
Adjust center link.
Lift links to long.
Adjust lift links.
Implement not level.
Level implement.
Implement not properly adjusted.
See implement operator's manual.
Center link in upper holes.
Move center link to lower holes.
Sway chains adjusted to short.
Lengthen sway chains.
Hitch drops slowly
Adjust rate-of-drop knob.
Hitch fails to lift or lifts slowly
Reduce load.
Adjust flow divider valve and /or change the allocation.
Low oil level.
Fill system with proper oil.
Hydraulic oil too cold.
Allow oil to warm.
Transmission-hydraulic oil filter clogged.
Replace filter.
Transmission-hydraulic filter screen clogged.
Clean or replace screen.
Implement will not operate at desired depth
Lack of penetration.
See implement operator's manual
Improper setting of limit stop.
Reset position limit.
Improper setting of draft lever.
See section “Rockshaft and Three-Point Hitch”.
Insufficient or no hitch response to draft load
Draft control lever in “Off” position.
Move lever rearward.
Lift links too short.
Flow divider valve closed
Adjust flow divider valve and/or change the allocation
Rate-of-drop too slow.
Adjust rate-of-drop valve.
Hitch too responsive
Move center link to upper holes.
Sensitivity valve set too responsive
Adjust sensitivity valve
Hitch drops too fast
Adjust rate-of-drop.
OULXA64,00002A7-19-20040701