Attaching PTO-Driven Implement

1. CAUTION: Shut off engine and disengage PTO before attaching PTO-driven equipment.

   CAUTION: High-inertia implements do not come to a standstill the moment the PTO control lever is shifted to the disengaged position. Do NOT approach the implement while it is “coasting down”. Do not work on the implement until it has stopped.

   CAUTION: Before attempting to clean, adjust or lubricate a PTO-driven machine, the three-point hitch or u.j. shaft, always make sure the PTO is switched off and stopped, the tractor engine is shut off and the ignition key is removed.

   Turn key off to stop engine.

2. Attach implement to tractor before connecting PTO drive line. Lock three-point hitch in upward position if it is not to be used.

3. Rotate PTO shield upward for clearance. With engine off, turn shaft slightly by hand if necessary to line up splines. Connect drive line to PTO shaft. Pull out on shaft to be sure drive line is locked to PTO shaft. Place PTO shield in downward position.

4. Be sure all shields are in place and in good condition. Never operate PTO unless master shield is properly installed. WITH ENGINE STOPPED, check integral shields on drive line by making sure they rotate freely on shaft. Lubricate or repair as necessary.

5. Check carefully for any interference, make sure three-point hitch is locked in the upward position if it is not used.