TIA - Requirements for Rear Hitch

Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the operator's manual of the implement.

While operating, implement has the ability to control hitch depth.

NOTE: Operator sets raise limit using tractor CommandCenter™. This limit cannot be exceeded by implement.

The following preconditions have to be met before transferring implement control.

• Operator sitting on seat.
• Hitch must be functional.
• Hitch control lever in neutral position.
• Hitch is not locked.

Transfer control using AutoTrac™ resume switch or TIA resume softkey as presented in the implement Operator's Manual.

To withdraw control:

• Actuate hitch control lever.
• Lock hitch (transport lock.)
• Actuate fender switch (if equipped).

NOTE: Unless the implement is authorized to adjust hitch depth when the tractor is stationary, the tractor prevents hitch depth from being controlled when stationary.