|
Wheel spindle positions are determined by tire size, pickup type, and crop conditions. (Refer to WHEEL SPINDLE POSITIONS in this section.)
1.
Lift one side of baler using a floor jack.
2.
Remove nuts, washers, and spindle.
NOTE:
If removed, install spindle mounting bolts with nuts on outside of machine. Exception: On MegaWide pickups, mount top pair of cap screws with nuts on inside of machine.
|
3.
Reposition wheel spindle and reinstall hardware. Tighten nuts to specifications.
Specification
|
Wheel Spindle Nuts (31 x 13.5 x 15)
-Torque
|
235 N·m
|
(173 lb-ft)
|
|
Wheel Spindle Nuts (21.5 x 16.1)
-Torque
|
339 N·m
|
(250 lb-ft)
|
4.
Repeat procedure on opposite side.
|