BALETRAK™ Pro Monitor-Controller Channels

NOTE: Channel listings and page numbers can be found under Operating the Baler or Service-Baler in the Contents or under section "C" in the Index.

NOTE: Monitor will power off after 30 minutes of inactivity.

  CUSTOMER CHANNELS  
Channel Number Contents Remarks
001 Reset all settings to factory Initial Settings See factory initial settings
002 Dry Straw Twine Wrap Program Plus key turns ON, minus turns OFF
003 Re-extension Twine tying Program Plus key turns on and increases, minus turns off and decreases (OFF, 8.0, 16.0, 24.0)
004 Cinch Wrap Twine tying Program Plus key turns ON, minus turns OFF
005 Calibration of bale size Diameter Sensor At value 208 for 467-567, 173 for 457-557
006 Net Wrap Delay Default value will be 2 (0-8) seconds
007 Calibration of right belt tension sensor At value 176
008 Measurement units Will display Sl for metric and En for English
009 Calibration of left belt tension sensor At value 176
010 Offset of near full alarm Initial setting is 4.5 (0.5-10.0) inches
011 Bale shape sensitivity Initial setting is 3 (1-5)
012 Test Of The Net Switch Released=12 & tone, depressed=00
013 Test Of the Oversize Switch Released=12, depressed=00 & tone
014 Test Of The Right Gate Latch Switch Released=12 & tone, depressed=00
015 Test Of The Left Gate Latch Switch Released=12 & tone, depressed=00
016 PTO RPM sensor output Read the speed
017 Pick up RPM sensor output Read the speed
018 Test of the Current in the actuators Read the current
019 Test of system voltage Read the voltage
020 Test of the LCD screen Display all segments
029 Twine Arm Calibration Value  
033 Delay of Twine Eject Icon Default 0 (0-10) Seconds

 

BaleTrak is a registered trademark of Deere & Company

OUO6085,00004DF -19-02JUL07-1/1