BaleTrak™ Pro Monitor-Controller System Introduction

BaleTrak™ Pro system Provides accurate and useful information to help an operator make the best bales possible.

In addition, the operator can adjust most control settings from the tractor seat without inconvenience or delays. By pushing a single button, twine arms can be extended or extracted, or auto wrap cycle can be initiated.

BaleTrak Pro system is factory preset, functional and ready to use. Operate baler briefly with factory settings to become familiar with the settings before adjusting or resetting them. The system will remember the settings when power is shut off.

NOTE: Monitor will power off after approximately 30 minutes of inactivity.

BaleTrak Pro system can be used to troubleshoot baler malfunctions and gives error code messages during malfunctions. Convenient channels are available to ensure correct baler switch and sensor adjustments.

BaleTrak Pro system monitors and/or controls the following baling operations and conditions:

• Bale Diameter
• Bale Shape
• Twine Wrapping
• Automatic Net Wrapping (if equipped)
• Bale Eject
• Bale Count
• Gate Closed
• Slip Clutch Alert
• Variable Core Diameter (if equipped)
• Alarms
  • Gate Open
  • Oversize Bale
  • Low Tractor Voltage
  • Net Wrap Misfed or Miscut (if equipped)
  • Error Codes of System Malfunctions

A-Monitor-Controller

BaleTrak is a registered trademark of Deere & Company

OUO6085,00004D9 -19-05MAY09-1/1