Adjusting Wheel Spindles with 31 x 13.5-15 Tires
Wheel spindle positions are determined by tire size, pickup type, and crop conditions. (Refer to WHEEL SPINDLE POSITIONS in this section.)
IMPORTANT:
When raising the baler with jack or hoist, place a jackstand or equivalent support under baler frame. Avoid placing jackstand under MegaWide™ Plus pickup frame.
1.
Park baler on level surface.
2.
Using a jack or hoist, raise one side of baler. Place jackstand or equivalent support under baler frame.
3.
Remove wheel.
4.
Remove nuts, washers, and spindle.
NOTE:
If removed, install spindle mounting bolts with nuts on outside of machine. Exception: On MegaWide pickups, mount top pair of cap screws with nuts on inside of machine.
5.
Reposition wheel spindle and reinstall hardware. Tighten nuts to specifications.
Specification
|
Wheel Spindle Mounting Hardware
-Torque
|
237 N·m
|
(175 lb.-ft.)
|
6.
Install wheel. (See TIRE INSTALLATION and WHEEL NUT TORQUE in this section.)
7.
Repeat procedure on opposite side.
|