Loading Twine Box

1. Open twine compartment door.

NOTE: Up to four balls of twine can be loaded into twine box by stacking on top of each other. Two twine balls shown.

2. Place one ball of good quality twine in each twine box. Be sure twine is pulled from end of the ball marked "top".

IMPORTANT: The twine knot must be small enough to pass through the guides and twine arm.

3. Stacked twine balls;

a. Join twine balls by tying the inside end of one ball to the outside of other ball.

  • Tie plastic twine balls together with a sheet bend knot.
  • Tie sisal twine balls together with a square or modified square knot.

b. Trim loose ends of twine as close to knot as possible.

4. Route twine through guides, as shown.

E53966

Right-Hand Side

E26419

Plastic Twine (Sheet Bend Knot)

E7986

Sisal Twine (Modified Square Knot)

OUO6077,0001924 -19-15MAR06-1/1