Hydraulic System Diagram

E48210


A-To Tractor SCV Ports
B-Tensioning Valve


C-Tension/Gate Cylinders


D-Twine Arm Cylinder - Manual Hydraulic Tie ONLY


E-Flow Valve - Manual Hydraulic Tie ONLY

Hydraulic system for the balers use the following major components:

  • Tensioning valve (B)-Used to direct oil flow, check flow, and limit hydraulic pressures.

  • Tension/gate ( double-acting ) cylinders (C)-Used to raise and lower the gate and to control bale tensioning.
  • Twine arm ( double-acting ) cylinder (D)-Used to actuate twine.
  • Flow Valve (E) - Used to regulate twine arm "sweep" time

NOTE: Twine arm cylinder (D) and flow valve (E) are used on balers with manual hydraulic tie.

OUO6078,00000A5 -19-01JUL08-1/1