OMFH309536: 458 Standard Round Baler (360001- ), Block File: OUO6085_00005FC_19

Adjusting Tractor Wheels

NOTE: Adjust tractor wheels toward upper end of specifications to improve:

Bale shape by crowding ends of pickup
Ability to pick up crop

Adjust front wheels to provide an inside tire-to-tire dimension of 1372-1524 mm (54-60 in.).

OUO6085,00005FC -19-15AUG06-1/2

Adjust rear tractor wheels to provide an inside dimension according to specifications. Do not exceed outside dimension limitations to prevent machine damage.

Tire-to-Tire Dimension
Four Foot Wide Baler	1372-1524 mm (54-60 in.) Outside dimension not to exceed 2591 mm (102 in.)

IMPORTANT: Do not make extremely short turns or cause the baler to jackknife while backing, as damage may occur to the PTO driveline, tractor tires, baler frame, and gathering wheels.

NOTE: If tread setting is too narrow, operator will not be able to make properly shaped bales without driving on windrow. This may result in bales with soft ends and loose twine. (See INTERPRETING BALE SHAPE INDICATORS and WEAVING IN THE WINDROW in Operating the Baler section.)

OUO6085,00005FC -19-15AUG06-2/2