Changing Baler Model Program (Channel 201)The monitor-controller software includes various model programs. Each program is written specifically for the baler model for which the monitor-controller was originally supplied. When replacing monitor-controller with a new unit, or moving monitor-controller to a different model baler, review and revise the model program if necessary. NOTE: The twine, net wrap, slip clutch alert, and optional variable core features will not operate correctly unless the model number displayed on monitor-controller matches baler model number. To Change Model Program:1. Turn tractor key to ON position. Do not start tractor. 2. Press and hold both COUNTER key (A) and NUMBER OF WRAPS key (B) while turning monitor-controller to ON. CH201 should be displayed. 3. Release both keys. Baler model is displayed. 4. Press PLUS or MINUS key to change to desired model. 5. Turn monitor-controller OFF to enter setting into memory. 6. Turn monitor-controller ON to verify baler model number. Which is displayed approximately 2 seconds. If displayed baler model number is incorrect, repeat Steps 1-6. 7. Turn tractor key to OFF position and remove key. |
|
PP98408,00000D5 -19-05OCT09-1/1 |