Twine Feature (Channel 202)
(Turning On and Off)
The twine feature can be turned OFF or ON by accessing Channel 202.
NOTE:
The twine feature will not operate correctly unless the model number displayed on monitor-controller matches baler model number.
Turning Feature On and Off:
1.
Turn tractor key to ON position. Do not start tractor.
2.
Press and hold both COUNTER key (A) and NUMBER OF WRAPS key (B) while turning monitor-controller to ON.
CH201
should be displayed.
3.
Release both keys. Baler model is displayed.
4.
Press and hold COUNTER key (A) and press the PLUS key until
CH202
is displayed.
5.
Release COUNTER key (A).
6.
Press PLUS or MINUS key to change displayed value to
(twine
OFF
) or
1
(twine
ON
).
7.
Turn monitor-controller OFF to enter setting into memory.
8.
Turn monitor-controller ON to verify baler model number. Model number is displayed approximately 2 seconds. If displayed baler model number is incorrect, (See BALER MODEL PROGRAM [CHANNEL 201] in this section).
9.
Turn tractor key to OFF position and remove key.
|
