OMFH309536: 458 Standard Round Baler (360001- ), Block File: PP98408_0000116_19

1. Assemble monitor-controller bracket (B) to base.

2. Attach base to window ledge. Fasten with three 5/16 x 1-3/4 in. cap screws (A).

A-Cap Screws, 5/16 x 1-3/4 in.
B-Bracket

PP98408,0000116 -19-16JUN09-1/3

3. Put monitor-controller (A) pivot bracket on top of mounting bracket. Fasten with M6 x 16 cap screw.

4. Route harness along right-hand side of cab, away from operating levers, and toward the rear of cab.

A-Monitor-Controller

PP98408,0000116 -19-16JUN09-2/3

5. Connect harness power plug to convenience outlet (A).

6. Route harness through grommet in back of cab, or drill a 44 mm (1-3/4 in.) diameter hole in rear wall if required.

A-Convenience Outlet

PP98408,0000116 -19-16JUN09-3/3