Resetting BaleTrak™ Pro Monitor-Controller To Initial Settings (Channel 001)

All adjustable monitor-controller settings can be simultaneously reset to initial settings using the following procedure:

1. Turn tractor key to ON position. Do not start tractor engine.

2. Press and hold COUNTER key (A) while turning monitor ON.

3. Release key; digital display should show 050 .

4. Simultaneously press and hold PLUS and MINUS keys until digital display changes from 050 to 099 ; then release keys.

NOTE: Display change is a visual indication that adjusted set points have reverted back to initial settings. (See BaleTrak™ Pro MONITOR-CONTROLLER SETUP VALUES AND INITIAL SETTINGS, in this section, to see which settings have changed.)

5. Turn monitor off to enter initial settings into memory.

  • If in English units, the reset values will be in English.
  • If in metric units, the reset values will be in metric.

6. Turn tractor key to OFF position. Remove key.

E52442


A-COUNTER Key
B-CH001 Displayed

PP98408,0000207 -19-10SEP09-1/1