|
False slip indication
|
Slip alarm sounds without PTO or pickup clutch slipping
|
Check pickup sensor by viewing rpm on channel 205, (See Slip Clutch Alert Pickup RPM Sensor in Operating with BaleTrak™ Pro System section)
|
|
|
|
Check PTO Speed on channel 204 is properly set, (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
|
|
Slip alert feature can be turned off, (See Turning On and Off Net Wrap, Slip Clutch Alert, and Variable Core in Service section)
|
|
|
Pickup rpm is higher than PTO sensor rpm
|
Reverse orange and brown terminals inside connector
|
|
One of the clutches slip but the slip alarm does not sound
|
Monitor not receiving PTO sensor input
|
Check PTO sensor by viewing rpm on channel 204, (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
|
Both sensors have not been activated
|
Check that both sensors are activated and PTO set at proper speed (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
Twine or net wrapping does not correct for slower speed
|
Improper sensor adjustment, faulty sensor, broken wires
|
Check PTO sensor by viewing rpm on channel 204, (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
|
|
Check PTO speed on channel 204 is properly set (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
| Symptom |
Problem |
Solution |
|
Pickup sensor is damaged
|
Wheel on clutch has contacts sensor
|
Remove starter roll and end play by adding washers between sprocket and spring pin at left-hand starter roll shaft (See Adjust PTO and Pickup Slip Clutch Alert Sensors in Service section)
|
|
|
|
Remove pickup clutch end play by adding washers between clutch and outside spring pin. Adjust gap between sensor and wheel. (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
PTO sensor is damaged
|
PTO slip clutch contacts sensor
|
Tighten or replace PTO driveline mounting screws
|
|
|
|
Check gear case shaft end play
|
|
|
|
Repair or replace gear case
|
|
|
|
Adjust gap between sensor and PTO clutch fins. (See Slip Clutch Alert PTO Speed Sensor in Operating with BaleTrak™ Pro System section)
|
|
Erratic pickup speed variation
|
Sensor gap changes
|
Remove starter roll and end play by adding washers between sprocket and spring pin at left-hand starter roll shaft (See Adjust PTO and Pickup Slip Clutch Alert Sensors in Service section)
|