Adjust Initial Length of Hydraulic Lift Cylinder (If Equipped)

1. IMPORTANT: If the hydraulic pickup lift cylinder has been removed, the initial length of cylinder must be adjusted before installing the cylinder.

   
   E39758-UN-20FEB96

   A - Distance

   Extend cylinder fully.

---




2. Install cylinder stop, jam nut, washer (MegaWide™ Plus pickup only) and end block onto cylinder rod.

3. Turn cylinder rod into end block until distance (A), from center of hole in base end of cylinder-to-center hole in end block, is within specifications.

   Item	Measurement	Specification
   Center of Hole in Base End of Cylinder-to-Center Hole in End Block	Distance (Initial Length)	606 mm (23-7/8 in.)

4. Install cylinder on baler.