BaleTrak™ Pro Monitor-Controller System Introduction

E52435-UN-16JUN03

A - Monitor-Controller

In addition, the operator can adjust most control settings from the tractor seat without inconvenience or delays. By pushing a single button, twine arms can be extended or extracted, or auto wrap cycle can be initiated.

BaleTrak™ Pro system is factory preset, functional, and ready to use. Operate baler briefly with factory settings to become familiar with the settings before adjusting or resetting them. The system remembers the settings when power is shut off.

NOTE: Monitor will power off after approximately 30 minutes of inactivity.

BaleTrak™ Pro system can be used to troubleshoot baler malfunctions and gives error code messages during malfunctions. Convenient channels are available to ensure correct baler switch and sensor adjustments.

BaleTrak™ Pro system monitors and controls the following baling operations and conditions:

• Bale Diameter
• Bale Shape
• Twine Wrapping
• Automatic Net Wrapping (if equipped)
• Bale Eject
• Bale Count
• Gate Closed
• Slip Clutch Alert
• Variable Core Diameter (if equipped)
• Alarms
  • Gate Open
  • Oversize Bale
  • Low Tractor Voltage
  • Net Wrap Misfed or Miscut (if equipped)
  • Error Codes of System Malfunctions