Baler Model Program (Channel 201)

E52456-UN-10JUN08

A - COUNTER Key

B - NUMBER OF WRAPS Key

The monitor-controller software includes various model programs. Each program is written specifically for the baler model for which the monitor-controller was originally supplied.

When replacing monitor-controller with a new unit, or moving monitor-controller to a different model baler, review and revise the model program if necessary.

NOTE: The twine, net wrap, slip clutch alert, and optional variable core features will not operate correctly unless the model number displayed on monitor-controller matches baler model number.

To Change Model Program:

1. Turn tractor key to ON position. Do not start tractor.

2. Press and hold both COUNTER key (A) and NUMBER OF WRAPS key (B) while turning monitor-controller to ON. CH201 must be displayed.

3. Release both keys. Baler model is displayed.

4. Press PLUS or MINUS key to change to desired model.

5. Turn monitor-controller OFF to enter setting into memory.

6. Turn monitor-controller ON to verify baler model number. Baler model is displayed for approximately 2 seconds. If displayed baler model number is incorrect, repeat Steps 1—6.

7. Turn tractor key to OFF position and remove key.