OMFH313140

Symptom	Problem	Solution
Crop pushing ahead of roller	Not enough float	Increase float (See ADJUST ROLLER BAFFLE FLOAT TENSION in Service section.)
	Tall stubble	Raise pickup
	Low drawbar	Add drawbar shield Adjust roller baffle height Raise pickup
	Incorrect baler hitch height	See ADJUST BALER HITCH in Preparing the Baler section.

Crop wrapping on roller

Plastic ties missing

Replace missing ties on roller

Tighten loose ties on roller

Roller not balanced

Crop not feeding under roller

Balance roller (See BALANCE ROLLER BAFFLE in Service section.)

Roller bouncing

Float too light

Reduce roller float spring pressure (See ADJUST ROLLER BAFFLE FLOAT TENSION in Service section.)

Pickup plugging	Crop pushing through compressor rack	Add compressor rods to each hole, except the outside hole on each end.
	In cornstalks, pickup stalls.	Disengage torsion spring for baffle or order Cornstalk Feeding Enhancement Kit. (See your John Deere dealer.)

PP98408,000108E-19-20130211