OMFH318462

Lift and Float System

Symptom	Problem	Solution
Platform Does Not Follow Ground Contour	Platform float hydraulic pressure too high	Adjust float pressure. (See Adjusting Platform Float in Operating the Windrow section.)
	Faulty platform float or platform run power relay	Replace power relay. (See your John Deere dealer.)
	Accumulator gas precharge pressure too low or high	See your John Deere dealer.

Platform Digs Into Ground and Pushes Hard	Guards digging into ground	Adjust guard angle. (See ADJUSTING PLATFORM GUARD ANGLE in Operating Windrower section.)
	Platform float hydraulic pressure too low	Adjust float pressure. (See ADJUSTING PLATFORM FLOAT in Operating Windrower section.)
	Accumulator gas precharge pressure too high or low	See your John Deere dealer.
	Platform float hydraulic pressure release valve open.	Close valve on valve block.

Platform Drops Too Fast Or Does Not Lower Smoothly	Platform float set too heavy	Adjust platform float. (See Adjusting Platform Float in Operating Windrower section.)
	Accumulator gas precharge pressure too high or low	See your John Deere dealer.

Platform Will Not Lift Or Lifts Too Slow	Binding lift linkage	Replace bent or worn parts.
	Platform float set too heavy	Adjust platform float. (See Adjusting Platform Float in Operating Windrower section.)
	Worn auxiliary pump	See your John Deere dealer.
	Low relief valve setting	See your John Deere dealer.
	Platform full of dirt	Clean platform.
	Malfunctioning priority valve	See your John Deere dealer.
	Faulty switch or relay	Replace switch or relay.
	Faulty solenoid or valve cartridge	Replace solenoid or valve cartridge.

RC48509,00005C0-19-20120815