Adjust Windrow Compressor Roll Height

Do not remove plastic tie bands (A) from pickup baffle roller. If tie bands are removed, crop can wrap around roller between rods and tube.

Replace missing tie bands as soon as possible.

E54551-UN-02MAY06

A - Tie Bands (2 used on 460R) (3 used on 560R)

1. 
   E54550-UN-02MAY06

   A - Carriage Bolt (2 each side)

   B - Rubber Belt

   Baffle height is adjusted by removing carriage bolts (A) and moving the top end of the rubber belt forward, or to the rear.

---




2. To increase baffle height from ground, move belt (B) to the rear holes. Fasten with carriage bolts (A).

3. To decrease baffle height from ground, move belt (B) to the front holes. Fasten with carriage bolts (A).

4. Repeat on the opposite side.

5. Adjust clearance between compressor rods and rotor strippers. (See Adjust Compressor Rods in Service—Baler section.)