Default ISO Monitor Settings

This table contains Default ISO Monitor Settings that were loaded when the machine was built. The items in the table below can be changed by the customer (using the monitor) if different settings are preferred. When the customer installs his own setting for any of these items, the new setting is saved by the monitor when it is turned off using the tractor key.

Feature	Setting
Number of Net Wraps	2 Turns
Time Delay Net Wrapping	2 seconds
Diameter of Maximum Bale	69 in.
Selected Bale Diameter	69 in.
Selected Soft Core Diameter	39.4 in.
Full Bale Alarm Offset	7.9 in.
Bale Shape Sensitivity	2
Speed Compensation Net and Twine Wrap	Checked = ON
Twine Spacing	2.0
Number of Left-Hand End Wraps	2.0
Number of Right-Hand End Wraps	2.0
Re-Extension Program	0 = OFF
Left-Hand End Distance of Twine Wrap	3.1 in.
Right-Hand End Distance of Twine Wrap	3.1 in.
Dry Straw Program	No Check = OFF
Cinch Wrap Program	No Check = OFF
Bale Rotation Sensor = Lower Drive Roll (Pickup) Speed Sensor	Checked = ON
ON—OFF Solenoid Valve	Must Stay Selected
Third Bale Shape Indicator	Checked = ON
PTO Speed Sensor	Checked = ON

Items in this table are presets in the monitor which must not be changed. They will appear on some of the screens displayed but do not change them. If they are changed, the monitor functions (and baler performance) will be adversely affected.