Adjust Oversize Bale Switch

1. 
   E48030-UN-15MAY00

   A - Lever

   B - Dimension, 13 mm (0.512 in.)

   C - Clearance

   D - Switch Screws

   E - Cap Screw

   Close and latch gate.

---




2. Raise oversize bale lever (A) to dimension (B) above lower end of slot.

   Lever-to-Lower End of Slot	Dimension	13 mm (0.512 in.)

3. Gate must be closed for oversize bale indicator to be displayed.

   Check bale lever-to-switch roller contact point. The switch contacts must be closed (indicator or alarm must be activated on the monitor-controller) and clearance (C) between switch arm and switch body within specifications.

   Switch Arm-to-Switch Body	Clearance	0.79—2.38 mm (0.030—0.100 in.)

4. If necessary, loosen switch screws (D) and bracket cap screw (E). Position switch so bale lever contacts roller at point shown.

5. Switch or switch bracket must not interfere with bale lever at any point of lever travel or damage to switch can occur.

   Raise lever to the top of slot to check for interference and binding. Adjust switch if necessary.

6. Confirm switch operation using monitor. (See TEST SWITCHES USING MONITOR in this section.)