Turn Net Wrap, Slip Clutch Alert, and Variable Core Features On and Off

The following features must be activated before operation. These features can also be turned off if desired.

Feature	Channel	ON	OFF
Net Wrap Operation (if equipped)	203	1	0
PTO Sensor	204	540 or 1000	0
Pickup Sensor (MegaWide™ Plus Pickup)	205	310	0
Pickup Sensor (MegaWide™ HC2 Pickup)	205	170	0
Variable Core Valve (if equipped)	208	1	0

Turning Features On and Off:

1. Turn the tractor ignition key to the ON position. Do not start the tractor engine.
2. Access the setup channels in the monitor-controller as follows:
   1. BaleTrak™ Pro Monitor: Press and hold both the COUNTER key and the NUMBER OF WRAPS key while turning the monitor-controller ON.
   2. BaleTrak™ Plus Monitor: Press and hold both the COUNTER key and the BALE DIAMETER key while turning the monitor-controller ON.
   3. Verify that CH201 is displayed on the monitor.
3. Release both keys. Verify that the correct baler model number is displayed.
4. Press and hold the COUNTER key and press the PLUS key until the desired channel is shown in the display.
5. Release the COUNTER key.
6. Press the PLUS or MINUS key to change the display to the desired value.
7. Turn the monitor-controller OFF.
8. Turn the tractor ignition key to the OFF position and remove the key.

• Accessing channel 205 and changing the value to 0 turns off the slip alert feature. Shutting off the pickup sensor on channel 205 still allows automatic speed compensation during the wrapping cycle.
• The entire system can be turned off by changing the channel 204 value to 0.

Slip Clutch Alert System

1. Changing the channel 204 setting to 0 disables the entire slip clutch alert system.
2. Changing the channel 205 setting to 0 turns the pickup drive speed sensor OFF. If the PTO speed sensor (channel 204) remains ON, the system still provides automatic speed compensation during the wrapping cycle.