Baler Model Program (Channel 201)

E84265-UN-28AUG17

BaleTrak™ Pro Monitor

E84266-UN-28AUG17

BaleTrak™ Plus Monitor

A - COUNTER Key

B - NUMBER OF WRAPS Key

C - BALE DIAMETER Key

D - PLUS Key

The monitor-controller software includes various model programs. Each program is written specifically for the baler model for which the monitor-controller was originally supplied.

When replacing the monitor-controller with a new unit, or moving the monitor-controller to a different model baler, review and revise the model program if necessary.

The model number displayed on the monitor must match the current baler model number. The twine or net wrap application, slip clutch alert, and optional variable core features only operate correctly if the model numbers match.

To Change Model Program:

1. Turn the tractor ignition key to the ON position. Do not start the tractor.

2. Access the Baler Model Program Channel 201 as follows:

   1. BaleTrak™ Pro Monitor: Press and hold the COUNTER key (A) and the NUMBER OF WRAPS key (B) while turning the monitor-controller ON.

   2. BaleTrak™ Plus Monitor: Press and hold the COUNTER key (A) and the BALE DIAMETER key (C) while turning the monitor-controller ON.

   3. Verify that CH201 is displayed on the monitor.

3. Release both keys. The baler model number is displayed.

4. Press the PLUS key (D) or the MINUS key to change to the correct model.

5. Turn the monitor-controller OFF to enter the setting into memory.

6. Turn the monitor-controller ON and verify the baler model number. The model number is displayed for approximately 2 seconds. If the baler model number displayed is incorrect, repeat the previous steps to change it.

7. Turn the tractor ignition key to the OFF position and remove the key.