Adjust Initial Length of Hydraulic Lift Cylinder (MegaWide™ Plus and Regular Pickup Only)

1. If the hydraulic pickup lift cylinder has been removed, the initial length must be adjusted before installing the cylinder.

   Extend the cylinder fully.

2. Install the cylinder stop, lock nut, washer (MegaWide™ Plus pickup only), and end block onto the cylinder rod.

3. Turn the cylinder rod into the end block until the distance (A), from the center of the hole in the base end of the cylinder to the center of the hole in the end block, is within specifications.

   Initial Cylinder Length	Distance	606 mm (23-7/8 in)

4. Install the cylinder on the baler.

E39758-UN-20FEB96

A - Distance