Adjust Initial Length of Hydraulic Lift Cylinder (MegaWide™ Plus and Regular Pickup Only)

1. If the hydraulic pickup lift cylinder has been removed, the initial length of cylinder must be adjusted before installing the cylinder.

   
   E39758-UN-20FEB96

   A - Distance

   Extend cylinder fully.

---




2. Install the cylinder stop, lock nut, washer (MegaWide™ Plus pickup only), and end block onto cylinder rod.

3. Turn the cylinder rod into the end block until the distance (A), from the center of the hole in the base end of the cylinder-to-center hole in the end block, is within specifications.

   Center of Hole in Base End of Cylinder-to-Center Hole in End Block	Distance (Initial Length)	606 mm (23-7/8 in)

4. Install cylinder on the baler.