-
Move baler to a dry place. If baler must be stored outside,
belt life can be prolonged by covering or removing belts to protect
from sunlight and ozone exposure.
-
Remove twine from twine boxes. Store twine inside during storage
season.
-
Clean baler thoroughly inside and out. Trash and dirt will draw
moisture and cause rust.
-
Apply a few drops of oil to all pivot points and linkages.
-
Thoroughly lubricate baler. (See Lubrication and Maintenance
section.)
-
Apply a thin layer of grease to threads of all adjustment bolts.
-
Retract all hydraulic cylinders.
-
Paint all parts from which paint has been worn.
-
Clean all chains by washing them with diesel fuel. Dry well
and coat with a heavy oil.
-
Put blocking under baler frame to take load off tires. DO NOT
DEFLATE TIRES. If exposed, put cover over tires to protect them from
light, grease, and oil.
-
If equipped with fire extinguisher, follow manufacturers recommendation
for inspection and maintenance. If baler is subjected to cold weather,
drain or treat fire extinguisher fluid with a nonflammable antifreeze
solution to prevent damage.
-
Check all belt guides for wear especially wear channels at rear
of tension arm. (See TENSION ARM WEAR CHANNELS in Lubrication and
Maintenance Section.)
-
List the replacement parts that will be needed and order them.