Adjust Initial Length of Hydraulic Lift Cylinder (If Equipped)

1. If the hydraulic pickup lift cylinder has been removed, the initial length of cylinder must be adjusted before installing the cylinder.

   
   E39758-UN-20FEB96

   A - Distance

   Extend cylinder fully.

---




2. Install cylinder stop, jam nut, washer (MegaWide™ Plus pickup only) and end block onto cylinder rod.

3. Turn cylinder rod into end block until distance (A), from center of hole in base end of cylinder-to-center hole in end block, is within specifications.

   Center of Hole in Base End of Cylinder-to-Center Hole in End Block	Distance (Initial Length)	606 mm (23-7/8 in.)

4. Install cylinder on baler.