Adjusting Lower Feed Roll Scraper

1. 

   
   TS698-UN-21SEP89

   
   E21748-UN-13SEP88

   A - Scraper

   B - Gate Roll

   To avoid injury or death caused by unexpected lowering of the gate, engage gate lock before working on, around, or under gate in raised position.

   Open gate fully.

---




2. Shut off tractor engine and remove key.

3. Lock the gate.

4. Loosen mounting lock nuts on scraper (A).

5. Using feeler gauge, adjust scraper (A) until roll-to-scraper clearance is within specifications at tightest points. Tighten lock nuts.

   Lower Front Gate Roll-to-Scraper	Clearance	2.5—5.5 mm (3/32—7/32 in.)

6. Rotate roll to make sure scraper does not hit roll at any point as roll is rotated.

7. Unlock gate and lower completely.