Using Dry Straw Twine Wrap Program (Advanced Operational Information) (Channel 002)

E52451
E52451-UN-18JUN03

A - COUNTER Key

B - PLUS Key

C - MINUS Key

When baling dry straw, it may be desirable to quickly place twine across full width of bale to prevent straw from flaking off in the baler.

The dry straw twine program provides for full speed twine arm movement from right to left, after the normal full speed starting pass from left to right. The twine arms will return to the right side, pause to place the set number of right-end wraps on the bale, and continue to apply twines as set in the monitor-controller.

To access program:

  1. Turn tractor key to ON position. Do not start tractor engine.

  2. Press and hold COUNTER key (A) while turning monitor-controller ON.

  3. Continue to hold COUNTER key (A) and press PLUS key (B) until CH002 appears in digital display.

  4. Release COUNTER key (A) and OFF should be displayed.

  5. Press PLUS key (B) to turn ON program.

  6. Turn monitor-controller OFF to enter setting into memory. This program will stay active until CH002 is accessed again and the MINUS key (C) is used to return display to OFF.

  7. Turn tractor key to OFF position. Remove key.

PP98408,00000CF-19-20090514