|
Discharge Chute Plugged
|
Travel speed too fast.
Grass too long.
Grass too wet.
Engine rpm not at wide open throttle.
Restricted air flow.
Belt installed incorrectly.
Increase deck rake to 12.7 mm (1/2 in.).
|
|
Patches Of Grass Uncut
|
Travel speed too fast.
Engine rpm not at wide open throttle.
Mower deck needs cleaning.
Mower deck belt has fallen off drive or deck sheaves.
|
|
Belt Slipping
|
Debris in sheaves.
Worn belt.
Belt tension is incorrect.
|
|
Too Much Vibration
|
Debris on mower deck or in sheaves.
Damaged drive belt.
Damaged sheaves or sheaves out of alignment.
Blades out of balance.
|
|
Blades Scalping Grass
|
Cutting too low.
Mower wheels not adjusted correctly.
Turning speed too fast.
Ridges in terrain.
Rough or uneven terrain.
Low tire pressure.
|
|
Mower Loads Down Tractor
|
Engine rpm too low.
Travel speed too fast.
Debris wrapped around mower spindles.
Mower height of cut is too low for grass load.
|
|
Uneven Cut
|
Mower deck not leveled properly.
Travel speed too fast.
Blades dull.
Mower wheels not adjusted correctly.
Tire pressure unequal.
|
|
Mower (Or Other Attachment) Stops When Vehicle Is Operated in
REVERSE
|
Normal condition. (See Using Reverse Implement Option in the
OPERATING section).
|
|
Mower (Or other attachment) does not engage
|
Check hopper presence switch (If hopper or discharge chute installed).
|