|
To unlock a locked receiver after a battery power loss, complete the following; pause no more than 15 seconds between steps:
1.
Press TUNE/SEEK. The display will show "000".
2.
Press SEEK as many times as needed to make the last two digits agree with your secret code.
3.
Press TUNE as many times as needed to make the first two digits agree with your code.
4.
Confirm that the code on the display matches the code you have written down.
|
5.
Press BAND. The display will show "SECURE" indicating that the receiver is operational and THEFTLOCK® is active (if "LOCKED" appears on the display, the incorrect code was entered. Repeat steps 1-5).
If the wrong code is entered 8 times, "InoP" will appear on the display. You MUST wait an hour with the ignition ON before you can try to unlock the receiver again. When you try again, you will only have three more chances to enter the correct code before "InoP" appears again.
If you lose or forget your code, contact your dealer.
|