Bottom Feeder House Door and Feedplate Seal Support

CAUTION: Raise feeder house, lower safety stop, shut off engine, set park brake and remove key.

Move lever (A) down and rearward to open door.

IMPORTANT: Lever will be bent if left down when feeder house is lowered.

Pull lever forward and up to close.

A-Lever

AG,OUO1035,1444 -19-10JAN00-1/2

If feeder house door is not sealing tight at (A) grain leakage could occur.

Loosen cap screws (B) on both sides.

Turn eccentric (C).

Tighten cap screw securing eccentric.

Tighten remaining cap screws.

A-Feeder House Door Seal
B-Cap Screws
C-Eccentric

AG,OUO1035,1444 -19-10JAN00-2/2