Drum Height Adjustment

causym CAUTION: Raise feeder house, lower safety stop, shut off engine, set park brake and remove key.

Open left- and right-hand feeder house side shields.

Adjusting bolts (A) are located on both sides of the feeder house.

Loosen nut (B).

For small grain, rotate bolt (A) until hole (C) aligns through side sheet. A wrench flat is provided on bolt. Tighten nut to specification.

To get 25 mm (1 in.) clearance for corn, loosen nut (B). Rotate bolt (A) until hole (C) is aligned in upper end of slot. Tighten nut to specification.

For grain slat clearance, loosen nut (D) and rotate cam (E) to get 3 mm (1/8 in.) slat clearance between slat and feeder house bottom on both sides. Tighten nut.

Cam (G) is not adjusted for corn.

Specification

Nut -Torque 115 N·m (85 lb ft)
Slat (Corn) -Clearance 25 mm (1 in.)
Slat (Grain) -Clearance 3 mm (1/8 in.)

H62137


A-Bolt
B-Nut
C-Hole
D-Nut
E-Cam

AG,OUO1035,1448 -19-10JAN00-1/1