Adjusting Knives

causym CAUTION: Shut off engine, set park brake and remove key.

Knives can be adjusted to any position. Position of knives determines the cut length of material.

IMPORTANT: Knives must be in the "out" (not cutting) position for corn.

For long material, loosen bolt (A) (both sides) and slide knives out. Tighten bolt.

For short material, loosen bolt (A) (both sides) and slide knives in. Tighten bolt.

NOTE: In heavy crop conditions, the chopper can be run on low speed with the knives out to save power and increase blade life. However, in certain conditions, chaff particles in the grain tank sample may increase slightly.


A-Bolt

H54540

Knives in the Out Position

H54541

Knives in the In Position

AG,OUO1035,1485 -19-13JAN00-1/1