Moving Chopper to Windrow Position

CAUTION: Shut off engine, set park brake and remove key.

Remove quick-lock pin (A) and pull arm (B) away and up to release chopper belt tension.

Install quick-lock pin to hold arm in the loose belt position (C).

A-Quick-Lock Pin
B-Arm
C-Loose Belt Position

AG,OUO1035,1486 -19-13JAN00-1/4

Switch (A), located on the left-hand side sheet above the rear axle, raises and lowers the chopper. Push switch up to raise the chopper.

Raise the chopper assembly until lock-out pins snap into place.

A-Switch

AG,OUO1035,1486 -19-13JAN00-2/4

Place drive belt (A) on top of guard (B) so belt does not turn while chopper is in the windrow position.

A-Drive Belt
B-Guard

AG,OUO1035,1486 -19-13JAN00-3/4

Disconnect low shaft speed connector (A) and connect to ground (B).

A-Low Shaft Speed Connector
B-Ground

AG,OUO1035,1486 -19-13JAN00-4/4