Lowering Chopper

1. Remove drive belt (A) from storage position.

A-Drive Belt

AG,OUO1035,1487 -19-13JAN00-1/5

2. Disconnect low shaft speed connector (A) from ground (B) and connect to wiring harness connector.

A-Low Shaft Speed Connector
B-Ground

AG,OUO1035,1487 -19-13JAN00-2/5

3. Place lower deflector door (A) in the middle position.

4. Release lock-out pins (B) on both sides. Pull pins rearward and rotate up until handle rest on lockout bracket (C).

A-Lower Deflector Door
B-Lock-Out Pins
C-Lockout Bracket

AG,OUO1035,1487 -19-13JAN00-3/5

5. Push switch (A) down to lower chopper.

A-Switch

AG,OUO1035,1487 -19-13JAN00-4/5

6. Place drive belt on desired drive speed sheaves.

7. Remove quick-lock pin (A).

8. Pull arm (B) out and down to put tension to drive belt. Secure arm in hole (C) with quick-lock pin.

A-Quick-Lock Pin
B-Arm
C-Hole

AG,OUO1035,1487 -19-13JAN00-5/5