|
Shut off separator.
Shut off engine, set park brake and remove key.
Shift single tine separator drive gear case to low.
Remove belt tension from feed accelerator drive by pushing lever up and out from notch in bracket.
Open stone trap and clean. Leave stone trap open.
Sound horn, start engine and set engine speed at mid idle.
Engage separator to clean out material from the single tine separator, discharge beater and chopper.
Shut off separator.
Shut off engine, set park brake and remove key.
Remove feed accelerator access covers and remove crop material from the accelerator area. After clearing the plug, rotate accelerator one revolution to be sure it is free.
|
Engage feed accelerator drive by pushing the lever up and into the notch in bracket.
Sound horn, start engine and set engine speed at mid idle.
IMPORTANT:
To prevent damage to engine PTO gear case and wet clutch, do not engage separator clutch with a plugged separator more than three times in a period of three minutes.
Engage separator. If the plug does not clear, disengage the separator.
Shut off engine, set park brake and remove key.
After separator is unplugged, close the stone trap and set concave spacing back to the original setting. Replace feed accelerator access covers.
If initially operating in high speed, shift single tine separator gear case to the high speed position. Adjust the single tine separator speed back to the initial setting and resume operation.
|