A-Hydraulic Hose
B-Jam Nut

C-Cylinder Belt
D-Cylinder Intermediate Belt

E-Bolts

F-Mounting

Run cylinder drive to slowest speed.

CAUTION: Shut off engine, remove key and set parking brake.

Disconnect hydraulic hose (A).

Loosen lock nut and jam nut (B) to loosen cylinder belt (C).

Roll cylinder belt (C) under belt (D).

Remove two bolts (E) and swing mounting (F) aside. Remove belt.

Install new belt. Adjust cylinder belt. See "ADJUSTING CYLINDER BELT IDLER".

Check intermediate belt alignment. See "ALIGNING CYLINDER DRIVE".

AG,OUO1035,1112 -19-11OCT99-1/1