CLIMATRAK™ Automatic Temperature Control

The CLIMATRAK ™ system consists of a temperature selector knob (A), mode selector switch (B), a fan speed control knob (C).

With the mode selector switch in the OFF position (bottom of switch pressed in), all power to the air conditioning system will be off.

In the ON position (middle position), power is supplied for normal functions.

In the DEFOG position (top of switch pressed in), power is supplied to the compressor regardless of temperature selection to remove moisture from the air even in the heat mode.

NOTE: The cab temperature sensor (E) is located behind the training seat. Do not cover this sensor or the system may not operate correctly in the AUTO mode.

The recirculation fan controls air coming out of the louvers. Fan speed control switch controls an infinitely variable fan. It also has a detent position for automatic fan speed operation. In this position, fan speed is determined by the difference between the selected temperature and actual cab temperature. As temperature approaches the set point, fan speed decreases.

The desired cab temperature is selected with the temperature selector dial. Turn dial to desired temperature setting.

IMPORTANT: If diagnostic light (F) is blinking see your John Deere dealer.

A-Temperature Selector Dial
B-Mode Selector Switch
C-Fan Speed Control Dial
D-Solar Sensor
E-Cab Temperature Sensor
F-Diagnostic Light

CLIMATRAK is a trademark of Deere & Company

AG,OUO1035,1328 -19-04JAN00-1/1