Fuse Locations

Fuses (A and B) are plug-in type and can be replaced.

IMPORTANT: Fuses can be pulled out. They are made with a tight fit for good contact. To prevent damage, pull straight out. Do not pry with a screwdriver, etc.

NOTE: Fuse contacts have thick preform coating applied from the supplier. It is recommended fuses be removed and installed three times to remove preform coating on contacts for proper seating to connector. Be certain pins to all connectors are properly seated prior to installation.

Each fuse is marked, by circuit, on the power distribution board. Be certain blades of fuse are started in socket when installing.

A-Fuses
B-Spare Fuses

AG,OUO1035,1571 -19-24JAN00-1/1