Relays

Relays (A) carry large electrical loads and are controlled by switches.

Relays in the central electronics box are on the power distribution boards #1 and #2 and optional power distribution board #3. Relays can be replaced.

IMPORTANT: Relays can be pulled out. They are made with a tight fit for good contact. To prevent damage, pull straight out. Do not pry with a screwdriver, etc.

NOTE: Relay contacts have thick preform coating applied from the supplier. It is recommended relays be removed and installed three times to remove preform coating on contacts for proper seating to connector. Be certain pins to all connectors are properly seated prior to installation.

Each relay is marked by function and are interchangeable.

A-Relays

AG,OUO1035,1572 -19-24JAN00-1/1