Cleaning Fan Switch (Black)

NOTE: Separator must be running to adjust fan speed.

This switch adjusts the speed of the cleaning fan. Push and hold plus (+) symbol to increase speed or minus (-) symbol to decrease speed.

The fan speed motor has a thermal (heat) shut off that will stop the motor from working if any of the following happen:

• Switch is used continuously for more than two or three minutes.
• Adjustment system is against the stop while the motor is still trying to change speed.
• Excessive binding or dragging in the linkage

If any of the above causes are suspected, clean and adjust the system as necessary.

Allow 10 to 15 minutes for the motor to cool, then try the switch again.

AG,OUO6075,267 -19-10AUG00-1/1