Digital Display Lines

The upper line (A) will only display the ground speed (MPH).

The middle line (B) and lower line (C) can display the same data. The operator can select any of the following data to be displayed on either line (middle or lower) of the display.

• Engine Speed (MPH)
• Threshing Speed (RPM)
• Fan Speed (RPM)
• Header Backshaft Speed (RPM)
• Concave Clearance as a relative number

To display engine and separator hours, press the hour/separator switch (D). The engine or separator hours along with the appropriate symbol will be displayed on the middle line. The hours will remain displayed for ten seconds or until another switch is depressed which will return the display to its previous mode.

Pressing the concave, fan speed or cylinder speed switches on the armrest will cause that function to be displayed on the tachometer. It will remained displayed for 10 seconds after the switch is released.

The middle and lower display will always show the last information displayed when the key was turned off.

Either the middle line or the lower line of the display can be changed by the operator to display any data of his choice.

The line that is currently active to change, will be shown by an indicator arrow (E) at the left side of the digital display. The appropriate arrow will be displayed when the operator pushes the up/down arrow key (F) which will move the display from the currently active line to the other line.

Pressing the concave speed, cleaning fan speed or the cylinder speed switches on the armrest will cause the digital display to display that function for 10 seconds after the function switch is released.

A-Upper Line
B-Middle Line
C-Lower Line
D-Engine/Separator Switch
E-Indicator Arrow
F-Up/down Arrow Key

HX,AG,SF6853 -19-07MAY99-1/1