Leveling Header (without CONTOURMASTER™)The header must be level when attached the feeder house. Raise the header to medium height. Take a position approximately 5 m (15 ft) in front of the header. Compare the bottom of the header with the combine front axle. IMPORTANT: Tires must be inflated to equal air pressure for accurate leveling adjustment. If the header is not level, remove cap screws (A) and move shims (B) from side to side on top beam of feeder house to level header. Install cap screws and tighten to specification. Specification
|
|
|
CONTOURMASTER is a trademark of Deere & Company | HX,AG,SF6944 -19-20JAN99-1/1 |